✅ Updated Nov 2026
Affiliate Disclosure: As an Amazon Associate, we earn from qualifying purchases. Links marked "Check on Amazon" are affiliate links — learn more.
⭐ Key Takeaways
Quick answer: Our top pick is NETGEAR 8-Port Gigabit Ethernet Switch (GS308), with TP-Link USB 3.0 to Gigabit Ethernet Adapter (UE300) as a strong alternative.

Nintendo DS multiplayer came in two flavours that players still mix up today. Local wireless linked consoles in the same room, with no internet involved at all. Nintendo Wi-Fi Connection was the online service behind matchmaking, trades and downloads. melonDS emulates both halves, but they behave very differently in 2026: the local half works between emulator instances, while the online half only exists because community-run replacement servers rebuilt what Nintendo switched off.

As an Amazon Associate, we earn from qualifying purchases.

This guide walks through both routes: local multiplayer between instances on one PC or a LAN, online play through community servers, the files Wi-Fi depends on, and the honest limits. Everything here assumes games and system files dumped from hardware you own.

This article contains affiliate links; if you buy through them, we may earn a commission at no extra cost to you.

Quick Answer

melonDS supports local multiplayer between instances on one PC or over a LAN using its local Wi-Fi emulation, and online play through community Nintendo Wi-Fi Connection replacement servers such as Wiimmfi and Kaeru WFC. Online play needs BIOS and firmware files from your own DS, a connection profile inside the emulated firmware, and either indirect mode for simplicity or direct mode over wired Ethernet.

Two Different Multiplayers, Two Different Fates

The DS treated local and online play as separate systems. Local wireless was a short-range radio link between nearby consoles, used for multi-card play, download play and trades in the same room. Nothing about it touched the internet, which is why it can still be emulated completely today: the traffic only ever had to travel a few metres.

Nintendo Wi-Fi Connection was the opposite design. Games connected through a home access point to Nintendo’s servers, which handled friend codes, matchmaking and features such as the Pokémon Global Trade Station. Nintendo discontinued the service on 20 May 2014, and every DS and Wii game lost its official online features that day. What survives is a community rebuild: volunteer-run replacement servers that speak the same protocol, so games can connect again as long as they are pointed at the right address.

That split explains everything that follows. Local play is an emulation problem, and melonDS largely solves it. Online play is an infrastructure problem, and melonDS can only take you to the door of servers others now run.

Local Multiplayer: Instances on One PC or a LAN

melonDS emulates the DS local wireless link, so each running instance behaves as one console. Launch two instances on one computer, start the same game in both, and open the game’s local wireless mode: the two virtual consoles find each other much like two real handhelds. Multi-card play and download play both ride on this link, making it the route for Mario Kart DS races at the same desk, or for trading between two of your own save files.

The same feature stretches across a home network. Under melonDS’s Wi-Fi settings, the local option called Bind socket to any address enables local multiplayer over a LAN, so instances on different computers can pair up. The FAQ adds that toggling it can also help same-machine setups connect, making it the first fix to try when instances on one PC cannot see each other.

Two cautions from the project belong in any honest guide. First, the FAQ is blunt that local multiplayer is timing-sensitive: the link depends on both instances staying in step, and the feature may not stay stable beyond two instances. Treat three- and four-console sessions as experimental. Second, both sides need matching game versions and regions, exactly as on real hardware.

Online Play Today: Community WFC Servers

With Nintendo’s servers gone, a DS game going online today needs to be redirected. Community projects rebuilt the Nintendo Wi-Fi Connection service; the names you will meet most often are Wiimmfi, Kaeru WFC and AltWFC. Run by volunteers, they restore matchmaking, friend play and trading for supported games. Support is per game, not universal: some titles work fully, others only partially or not at all.

The redirection mechanism is deliberately old-fashioned, because the games are old. A DS game looks up Nintendo’s server addresses through DNS, so pointing the connection profile’s DNS at a community server’s address sends the game to the replacement instead. On melonDS this setting lives where it always lived: inside the emulated console’s Wi-Fi connection settings, reached from a game’s Nintendo WFC menu. Some games also need help accepting the new server; the Wiimmfi community’s technique for DS titles lets many games connect using an unmodified dump plus the DNS change. Either way, the game image comes from your own cartridge, and any patching is applied to your own dump.

melonDS gives the traffic two ways out of your PC. Indirect mode routes the emulated console’s traffic through the emulator’s own networking layer, needs no special permissions and no particular adapter, and is the mode to try first. Direct mode forwards traffic straight onto your host network using libpcap, with an adapter chosen in the Wi-Fi settings. It is the more faithful route and rescues some stubborn games, but it asks more of you: wired Ethernet and administrator or superuser privileges, per the project’s FAQ. One detail follows from how the emulator works: the DS’s own wireless limits, such as its ancient security support, do not apply here, because the emulated console rides on your computer’s modern connection.

The Files Wi-Fi Needs: Your Own Firmware

melonDS networking leans on the real system software. The emulator requires BIOS and firmware dumps from a DS you own: bios9.bin (4KB ARM9 BIOS), bios7.bin (16KB ARM7 BIOS) and firmware.bin (a 128KB, 256KB or 512KB dump, depending on the model). The project provides no substitutes for these files, and this guide points to none: dumping your own is the only route described here.

The firmware matters for multiplayer because the DS stores its Wi-Fi connection profiles inside it. Your connection slots, the DNS entries for a community server, and the console’s online identity all live in that firmware data. That is also why each instance that goes online should have its own firmware dump or at least its own configured profile: two instances sharing one identity look like one console arriving twice, and servers and games both dislike that. Set the files under Emu settings, in the DS-mode tab, before troubleshooting anything else.

Setup Walkthrough

For local multiplayer, install melonDS on each machine, point every instance at your own BIOS and firmware files, and load the same game, same region, in each. On a single PC, open two instances side by side; across a network, enable Bind socket to any address in the Wi-Fi settings on both sides and let melonDS through your firewall. Then enter the game’s local wireless lobby in both instances and let them pair.

For online play, start in indirect mode. Boot a game, open its Nintendo WFC settings, and edit a connection profile: the emulator supplies the underlying connection, and your job is the DNS field, which takes the address published by the community server you have chosen. Run the connection test the game offers; success means the emulated console reached the replacement server. If a supported game still refuses to connect, try direct mode: wire the PC to Ethernet, install the packet capture library your platform needs, run melonDS with the necessary privileges, and select the wired adapter in the Wi-Fi settings.

Whichever route you take, test with patience: these are community servers, lobbies are quiet, and some in-game features were never restored.

Gear That Makes Multiplayer Sessions Easier

NETGEAR 8-Port Gigabit Ethernet Switch (GS308)

NETGEAR 8-Port Gigabit Ethernet Switch (GS308)

NETGEAR 8-Port Gigabit Ethernet Switch (GS308)

Check price on Amazon

LAN multiplayer and direct mode both prefer wired networking; a small switch gives every machine a cable.

Specs:
– 8 Gigabit Ethernet ports
– Model GS308-300PAS
– Fanless metal enclosure, silent operation

See it on Amazon

TP-Link USB 3.0 to Gigabit Ethernet Adapter (UE300)

TP-Link USB 3.0 to Gigabit Ethernet Adapter (UE300)

Check price on Amazon

Laptops without an Ethernet port need an adapter before direct mode’s wired route is even an option.

Specs:
– USB 3.0 Type-A to Gigabit Ethernet (10/100/1000)
– Model UE300
– Foldable, bus-powered design
– Works with Windows, macOS and Linux

See it on Amazon

Cable Matters Cat6 Ethernet Cable, 25 Feet

Cable Matters Cat6 Ethernet Cable, 25 Feet

Cable Matters Cat6 Ethernet Cable, 25 Feet

Check price on Amazon

A long patch cable lets a PC reach the router or switch without rearranging the room.

Specs:
– Cat6 rated to 550 MHz
– 24 AWG bare copper conductors
– 25-foot length

See it on Amazon

Samsung T7 Portable SSD 1TB (MU-PC1T0T/AM)

Samsung T7 Portable SSD 1TB (MU-PC1T0T/AM)

Samsung T7 Portable SSD 1TB (MU-PC1T0T/AM)

Check price on Amazon

A fast portable drive keeps your library, firmware dumps and saves together across two machines.

Specs:
– 1TB capacity, model MU-PC1T0T/AM
– Reads up to 1,050 MB/s, writes up to 1,000 MB/s
– USB 3.2 Gen 2, USB-C connection
– AES 256-bit hardware encryption

See it on Amazon

8BitDo Pro 2 Bluetooth Controller (Hall Effect)

A proper controller with drift-resistant sticks beats a keyboard for all but the most stylus-heavy games.

Specs:
– Hall Effect joysticks
– Bluetooth and wired USB-C connection
– Two pro-level back paddle buttons
– Compatible with Windows, Android, macOS and Switch

See it on Amazon

How to Choose

Choose the local route for playing with someone in the same home, trading between your own games, or running download play: it needs no servers, no DNS changes and no accounts, and it is the most reliable multiplayer melonDS offers. Choose the online route if a specific game’s restored features are the point, and accept the setup and per-game support lottery that come with it.

Within online play, choose indirect mode first, and move to direct mode only when a game fails to connect or behaves badly; wired Ethernet and elevated privileges are a fair trade only when they fix something. For hardware, wire everything you can: every mode behaves better on Ethernet than on busy Wi-Fi.

Who Should Skip

Skip online play if you expect a modern matchmaking experience: lobbies are small, support varies by game, and the project itself still describes Wi-Fi as a work in progress. Skip local sessions of three or four instances if stability matters, since the developers warn the timing may not hold beyond two. Skip melonDS multiplayer entirely if you will not dump BIOS and firmware files from your own DS; there is no legitimate shortcut. And if your interest is single-player only, none of this setup is necessary.

FAQ

Does melonDS online play still work after Nintendo shut its servers down?

Not through Nintendo: the official service ended on 20 May 2014. Online play works because community replacement servers, such as Wiimmfi and Kaeru WFC, rebuilt it. You redirect your own game dumps to them with a DNS setting in the emulated console’s connection profile; support varies by game.

Can two people play on one computer?

Yes. Run two instances, load the same game in both, and use the game’s local wireless mode. Enabling Bind socket to any address can help the instances find each other. The project warns the link is timing-sensitive and may not stay stable beyond two instances.

Why does online play need my DS firmware?

Because the DS keeps its Wi-Fi connection profiles, including DNS settings, inside the firmware, and melonDS uses your dumped firmware’s profiles and console identity for networking. It requires bios9.bin, bios7.bin and firmware.bin from your own DS and supplies no replacements.

What is the difference between indirect and direct mode?

Indirect mode routes traffic through the emulator’s built-in networking and needs no special setup or permissions. Direct mode forwards traffic onto your real network with libpcap, which can fix stubborn games but needs wired Ethernet and administrator privileges.

Final Verdict

melonDS online multiplayer is really two features wearing one name. Local Wi-Fi emulation is the dependable half: two instances, one room or one LAN, and most local modes simply work, with the two-instance stability warning kept in view. The online half is a community achievement rather than an emulator feature, and melonDS’s job is to deliver your own games to replacement servers cleanly, which its two modes do with different levels of fuss. Set up local play first, treat online as a bonus, and the DS’s multiplayer era stays playable.

Explore Our Guides & Free Tools